Temporary external fixator applied to a fractured pelvis can reduce internal hemorrhage dramatically and literally save someone’s life who is at risk from loss of blood.
Advantage of External Fixation of Pelvis
Pelvis bleeding after fracture of the pelvis ring is cause largely by tearing of pelvis veins which continue to bleed under low pressure until the lost blood fills the space it is in. only when the pressure of extravasated blood equals the venous pressure will bleeding stop. This could and often is only when the patient bleeds to death.
This procedures provides counter pressure or temponade which stops venous bleeding.
Pelvic fixator may be applied quickly under local anesthesia through small skin puncture wounds and only takes a few minutes. Always take care not to compromise later surgery when placing the Schanz screws and as soon as the patient is haemodynamically stable check the pin position. The fracture will require more accurate investigation with CT scanning and may require internal fixation when it is safe to do so.
It is important to remember that external fixation (whether supra acetabular or iliac crest) predominantly controls and stabilizes the anterior pelvic ring. In most cases supplemental stabilization or fixation is required for associated posterior pelvic ring injuries.
It could be difficult to apply this in obese patients.
It could also lead to definitive stabilization of some fractures such as rotationally unstable but vertically stable injuries.
The procedure is relatively contraindicated in case of iliac wing fractures.
Procedure of External Fixation of Pelvis
Preoperative assessment x-rays must be done. These include inlet, outlet, & AP views of pelvis. A CT is desirable but may be postponed because patient needs urgent stabilization.
Intra-operative fluoroscopy is helpful and guides pin placement and reduction. But it may not be available at all centers.
Positioning and Draping
Patient is placed supine [flouroscopy table is if available]. Area from approx 5 cm above umbilicus to groin is prepped and draped. It includes bilateral flanks [ilium].
A large bean bag perpendicular to the patient’s torso helps to stabilize the patient.
It is important that the pelvis be manually reduced as much as possible prior to pin insertion.
If pelvis is unstable with vertical migration or posterior displacement, then traction is used through supracondylar femoral pin insertion.
Compression force can also be provided by tying a large towel around pelvis .
Pins and Frames
Schanz pins should be at least 5 mm in diameter. Smaller pelves as in children require 4-mm pins.
Pins used should be of adequate length, to allow for postoperative swelling and the need for anteriorization of the frame.
Frame construct should be planned beforehand. A double frame construct allows for postoperative manipulation of one frame without losing the reduction.
A frame too close to abdomen may cause impingement if abdominal distension occurs.
When pins are placed along the iliac wing, the number may vary from two to three. In case of alternative method [described below], single pin may suffice.
First pin is usually placed about 2 cm posterior to anterosuperior spine. Rest of pins should then be placed along iliac crest using external fixation clamp to determine the proper pin spacing.
A small incision on the iliac crest allows to find appropriate orientation of wing and prevent skin tension on pins;
Pins are preferably placed in the outer half of the iliac crest in order to avoid cortical perforation and directed toward the acetabulum, so that the pins are angled toward the patients head.
Cranially directed pins may cause be impingement on the patient’s abdomen when sitting.
If C-arm image intensifier is available, pin placement can be confirmed at time of insertion by using fluoroscopy.
This method inserts pins distal to anterior superior iliac spine and anterior inferior iliac spine.
It is preferably done underfluoroscopic guidance.
Commercially Available External Fixators for Pelvis
There are many commercially available pelvic fixation devices available like C-clamp or Orthofix devices. These devices have advantages of quicker application and readiness.
After Care of External Fixation of Pelvis
Depending on patient position, patient might require intensive resuscitation efforts till stabilization. If internal fixation is contemplated, the fixator is kept only temporarily.
In some patients though, the fixator might serve as definitive treatment and is kept for about 12 weeks. When it is removed, pelvis should be examined under fluoroscopy to make sure it is stable.
Depending on fracture configuration, the weight bearing may be allowed with fixator in situ.
Weight bearing is generally allowed if posterior stability is present. In case there is posterior instability, weight bearing is not allowed though patient is allowed to sit.
Complications of External Fixation of Pelvis
- Pin tract infection
- Loosening of pins
- Injury to lateral cutaneous nerve
- Pressure sores
- Bladder incarceration may result from the reduction of pubic symphysis diastasis especially when the bladder is herniated.